Advertisement
SPECIFICATIONS
Overall System
Frequency:
Group 1: 1A (517.6MHz) +1B (533.7MHz)
Group 2: 2A (521.5MHz) +2B (537.2MHz)
Frequency Response: 80~20000Hz at ±3dB
Frequency Stability: 30 ppm
Modulation Mode: FM
Maximum Deviation: +/-55 KHz
Audio Dynamic Range: >100dB
S/N: >100dB
T.H.D: <0.5%
Operating Range: 50M
Operation Temperature: -68°F~122°F
Receiver
Mirror Image Rejection: >50dB
LINE Input Sensitivity: 380mV/-8.5dB
MIC Input Sensitivity: 5mV/-46dB
LINE Input Impedance: 20 K
MIC Input Impedance: 50 K
Power Supply: DC 12V/200mA
Power Dissipation: <800mW
Handheld Microphone
Mic Capsule: Dynamic
Antenna: Built-in Housing
RF Output: <10mW
Spurious Emission: <-40dB
Power Supply: 2x 1.5V A A Batteries
Power Dissipation: <250mW
www.PyleUSA.com
4
HANDHELD MICROPHONE
1
2
3
1. Grille (Capsule inside)
2. Display of frequency
3. Power ON/OFF Switch
4. Battery Compartment / Cover
Operation
1. Open battery cover. Install the provided 2pcs 1.5V A A batteries and then close
the cover. Pay attention to the correct polarity.
2. Slide power switch to ON position, display will be illuminated.
3. Now receiver RF indicator should light (Please conrm frequency of microphone
same as that of receiver before operation).
4. During operation if display is extinguished, this indicates the battery is Iow.
Please replace new battery.
5. If the microphone is not going to be used for any length of time, please slide
power switch to OFF position and remove the battery.
4
1
www.PyleUSA.com
Advertisement
