Gobo ECO Spot C40PCE User Manual

ECO Spot™ C40PCE User Manual
Thank you for choosing an ECO Spot™ Gobo projector.
This manual covers the ECO Spot PCE Series models.
Please read this manual before installing or operating the fixture,
follow the safety precautions listed below and observe all
warnings.

Package Contents


Projector with power cord

Test Gobo

Spare gobo retaining ring

Mounting hardware for yoke

Safety Information

•
Please unpack and carefully check for damage caused during transportation.
•
Light fixtures should be installed and maintained only by qualified personnel
with experience in lighting equipment and general electrical experience.
•
When suspending the fixture above ground level, verify that the structure can
hold at least 10 times the weight of all installed devices.
•
Verify that all external covers and rigging hardware are securely fastened and
use an approved means of secondary attachment such as a safety cable.
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft. (0.3m).
•
Provide a minimum clearance of 4 in. (10cm) around air vents.
•
Use only genuine spare parts for part replacement.
•
Do not look directly into the lamp; it can result in eye damage.
•
Always unplug the unit from the power mains before any service is done.

Electrical Safety

•
Disconnect the fixture from AC power before handling it.
•
Always ground (earth) the fixture electrically.
•
Use only a power source that complies with local building and electrical codes
and has both, overload and ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged
or defective, or if they show signs of overheating.
Copyright © 2019 Globus New Media LLC
ECO Spot PCE-Series User Manual
Page 1