Table of Contents
Advertisement
Quick Links
ECO Spot™ LED40D User Manual
Thank you for choosing an ECO Spot™ Gobo projector.
Please read this manual before installing or operating this fixture,
follow the safety precautions listed below and observe all warnings.
WARNING!
Some models are equipped with a voltage selector switch on the back plate of the
unit. Select the correct Line Voltage before Operating.
Package Contents
Projector with power cord
Test Gobo
Spare gobo retaining ring and spare drive belt
Gobo adapter for D- to E-Size gobos with retaining ring
Safety Information
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft (0.3m).
•
Provide a minimum clearance of 4 in (10cm) around air vents.
•
Use only genuine spare parts for part replacement.
•
Do not look directly into the lamp; it can result in eye damage.
•
Always unplug the unit from the power mains before any service is done.
•
Light fixtures should be installed and maintained only by qualified personnel with
experience in lighting equipment and general electrical experience.
Electrical Safety
•
Disconnect the fixture from AC power before handling the fixture.
•
Always ground (earth) the fixture electrically.
•
Use only a power source that complies with local building and electrical codes and
has both, overload and ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged,
defective or wet, or if they show signs of overheating.
Copyright © 2014 Globus New Media LLC
ECO Spot LED40D User Manual
Page 1
Advertisement
Table of Contents
Related Manuals for Gobo ECO Spot LED40D
Summary of Contents for Gobo ECO Spot LED40D
- Page 1 Test Gobo Spare gobo retaining ring and spare drive belt Gobo adapter for D- to E-Size gobos with retaining ring Safety Information • Place your fixture at a suitable place with good air flow. • Keep flammable materials away from the fixture.
- Page 2 When used for the first time, the lens will often need to be twisted outwards many rotations to reach the focusing point. • Turn on the gobo rotator with the push-button in the back and switch it off when the gobo projects in the desired position. •...
- Page 3 For E-Size gobos, use the screw-in adapter ring. For larger gobos, remove the adapter ring and use the larger retaining ring. • Push the two pins of the gobo retaining ring together and pull out the retaining ring. Carefully remove the old gobo and replace it with the new gobo. •...
- Page 4 ECO Spot LED40D User Manual Larger ID up to 40mm is possible with Line Voltage some loss in focusing quality, for optimal focus stay within 32mm image size. An If your model is equipped with a Line adapter for the smaller E-Size gobos is Voltage Selector in the back, select the included.
Need help?
Do you have a question about the ECO Spot LED40D and is the answer not in the manual?
Questions and answers