Advertisement
5.3.
drop a large washer (8) over an adjustable screw (3) and screw a lift handle (2) onto the top of the adjustable screw. Screw the lift
handle approximately half way down the threads. Make up the second adjustable screw in the same way and have both assemblies
ready to drop through the slot in the main guide beam after the beam has been placed over the engine bay.
5.4.
The chains should also be attached when the guide beam is mounted over the engine.
6. OPERATION
Note:
numbers in brackets refer to item numbers shown in fig.1
6.1.
The fully assembled support beam is very heavy and should be lifted into place by two people.
6.2.
loosen the grip knobs (6) to allow the assemblies to slide and then locate the rubber feet into the gutters of the vehicle's front wing
panels or close to the suspension strut towers.
Note:
Refer to the manufacturer's handbook to identify engine lifting brackets.
6.3.
drop the adjustable screw assemblies through the slot in the main beam in positions adjacent to the engine lifting points.
6.4.
Attach the ends of the chain to the lifting brackets on the engine.
6.5.
The chains may be attached to the lifting hooks in a single or looped chain configuration.
6.6.
lower the adjustable screws and hook the chains around the hooks. In all cases ensure that at least one link of the chain is hooked
over the lifting hooks.
6.7.
Tighten both grip knobs (6).
6.8.
Progressively rotate the lifting handles (2) clockwise to tighten the chains and support the engine.
6.9.
on completion of the maintenance task, rotate the lifting handles anticlockwise to release the tension on the chains.
6.10.
Unhook the chains, loosen both grips (6) and remove the engine support from the vehicle.
6.11.
Remove the chains from the engine lifting points.
ENVIRONMENT PROTEcTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: no liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey limited
01284 703534
sales@sealey.co.uk
Original Language Version
www.sealey.co.uk
eS502.V2 Issue 2 (HF) 20/08/18
Advertisement
