Yale UNI-TJ50BC Series Installation Instructions

UNI Stop/Holder
UNI-TJ50BC Series
Sized Closers
UNI-TJ51(BF) Series
Multi-Sized Closers
Right Hand Door - RH
Left Hand Reverse - LHR
Right Hand Door - RH
Left Hand Reverse - LHR
!
NOTE: For special applications a separate door and frame preparation template is packed with these instruction. Use this
instruction sheet for installation sequence and closer adjustments only.
!
It is recommended that the door, on which the door closer will be installed, be hung on ball bearing hinges. Door must swing
freely.
!
Door and Frame must be properly reinforced, or use of special fasteners employed, to prevent the mounting screws from pulling
out.
!
All dimensions are given in inches with corresponding metric dimensions (millimeters) in parenthesis.
Components
Power Adjustment Screw (3/16 Hex Drive)
Closer
Size
Stamp
Pinion Cap
Installation Instructions
Non Handed Door Closers
Door Stop...Door Holder...Door Closer
(On-Off Hold-Open Control) Not UL Listed
"BC" Valve
"L" Valve
"S" Valve
These installation instructions cover either of the models illustrated.
80-9350-2517-010 (06-09)
AN INCORRECTLY INSTALLED OR IMPROPERLY
ADJUSTED DOOR CLOSER CAN CAUSE
PROPERTY DAMAGE OR PERSONAL INJURY.
THESE INSTALLATION INSTRUCTIONS SHOULD
BE FOLLOWED TO AVOID THE POSSIBILITY OF
MISAPPLICATION OR MISADJUSTMENT.
Series UNI-TJ50
Door Stop...Door Closer
UL Listed for Fire Doors
Series UNI-TJ150
Non Hold Open &
Hold Open (TJ150) Models
Sized
(Sizes 2,3,4,5,6)
UNI-TJ52BC UNI-TJ152BC
UNI-TJ53BC UNI-TJ153BC
UNI-TJ54BC UNI-TJ154BC
UNI-TJ55BC UNI-TJ155BC
UNI-TJ56BC UNI-TJ156BC
Right Hand Reverse - RHR
Right Hand Reverse - RHR
2 sex-nuts
Rod Unit
(Arm Number
Stamp)
Main-Arm
Screw
Rod Screws
Slide Unit
Holder Control
Multi-Sized
(Sizes 3 thru 6)
UNI-TJ51
UNI-TJ151
(Sizes 1 thru 4)
UNI-TJ51BF
UNI-TJ151BF
Left Hand Door - LH
Left Hand Door - LH
Optional Cover
Optional Thru-Bolt
&
Grommet Nuts