Maintenance - Intertek Power Fist User Manual

V4.0
6. To prevent accidents, turn off the tool and disconnect its power
supply after use. Allow to cool completely on a non-flammable
surface out of children's reach after use. Clean, then store the tool
indoors out of children's reach.

MAINTENANCE

Before making any adjustments or changing accessories, turn off the
tool, disconnect it from its power source, and allow the tip to cool.
1. Keep the vent passage clear from dirt. Clean off the accumulated dust
and oil dirt periodically.
2. During normal operation, if anything happens, the power
supply should be cut off at once and the tool should be checked
and repaired.
3. Clean the blade after each use.
4. Check for damaged parts. Before using any tool, any part that
appears to be damaged should be carefully checked to determine that
it would operate properly and perform its intended functions. Check
for alignment and binding of moving parts, for broken parts or
mounting fixtures, or for any other condition that may affect proper
operation. Any part that is damaged should be repaired or replaced
by a qualified technician.
5. When servicing, use only identical replacement parts. Only use
accessories intended for use with this tool. Replace damaged
parts immediately.
6. Keep the tool clean. Wipe the tool with a clean cloth and periodically
blow out all areas with compressed air. If compressed air is not
available, use a brush to remove dust from all areas. Do not use
harsh chemicals or solvents to clean the tool. These chemicals could
seriously damage the plastic housing.
Visit www.princessauto.com for more information
130 Watt Electric Hot Knife 8571515
11