Advertisement
1 Unpack unit carefully. Make sure that it is in good
condition. It is important that you keep packaging for
warranty/service return.
2 Check that the valves are fitted properly. The
valves will normally come fitted, so a visual check
that they are upright is normally all that is necessary.
If not see the section on "changing valves".
3, Connect the power lead between the power
supply unit and the pre-amp.
lead is permanently connected at the power supply
unit. Do not attempt to remove it.
Please note that the PS1.2 is not compatible with
the PSU from the earlier PS1.1 or PS3
4, Connect to turntable and amplifier.
Making sure that you connect the "earth" leads form
the turntable to the post on the rear. (if any)
5 Connect the power supply unit, And site it away
from the preamp. Connect to the mains AC using the
LAYOUT
3 Quick set up guide
Please note the power
supplied IEC mains lead. If for some reason the
welded plug must be removed, please remove fuse
and dispose of immediately. (As they can be a
danger to children if plugged in). The replacement
plug should be wired in the following way Brown to
Live
terminal,
Blue
Green/Yellow to Earth terminal.
6 SWITCH ON! The LED mains indicator should light
up and unit will start working after about 15 seconds.
All valves should have a visible orange glow from the
cathode heaters. Full quality will be reached in 5
minutes.
7, Moving Magnet or Moving Coil?
If your PS1 is fitted with the optional x10 step-up
transformers (designated by PS1 MC on the rear)
you can select between MM and MC by the selector
switch on the front. Otherwise the selector should be
left in the "MM" position. High output MC pickups
3
to
Neutral
terminal
and
Advertisement
