Table of Contents
Advertisement
Riello 7200/2 HV PLUS
7 Receiving the product
The solar storage cylinders Riello 7200/2 1500 HV PLUS are
supplied in a single package, protected by a nylon bag
and put on wood pallets.
7000/2 1500 HV PLUS
Model Riello 7200/2 2000 HV PLUS are supplied in two sep-
arate packages:
- the first package is composed of the painted tank, pro-
tected by a nylon bag and put on wooden pallets.
- the second package, also protected by a nylon bag, is
composed of the polyurethane insulation with an el-
egant outer covering, the outer trim rings of the pipe
coupling, the top cover, the flange covers, the identifi-
cation labels and the documentation.
The following material is supplied in a plastic envelope
inside the package:
- Instruction booklet
- Hydraulic test certificate
Two magnesium anodes are also available, supplied ei-
ther already fitted or in a cardboard box on the pallet
8 Handling
The handling of the storage cylinder is carried out with
equipment that is suitable for the weight of the appli-
ance.
To remove the storage cylinder from the pallet, cut the
straps (1).
For models 7000/2 1500 HV PLUS these can be found under
the insulation near the hinges.
To lift the 7000/2 1500 HV PLUS storage cylinders, there is a
plug (2) with a hole where a lifting hoop (Ø 10 mm) suita-
ble for the weight of the tank can be inserted.
To lift the 7000/2 2000 HV PLUS storage cylinders, after re-
moving the insulation, bind the high part of the boiler
with a cord that can bear the weight and carefully lift it.
It is possible to dismantle the insulation covering to
make it easier to get through the door of the boiler
room.
Use suitable accident-prevention protections.
It is forbidden to dispose of the packaging material
and keep within children's reach, as it may be a po-
tential source of danger.
7000/2 2000 HV PLUS
The instruction booklet is an integral part of the
storage cylinder and it is recommended that it be
read and kept safe.
INSTALLING THE MAGNESIUM ANODES
Proceed as follows to install the magnesium anodes:
- Remove the protective plugs
- Fit the two magnesium anodes in the fittings (1) and (2)
- Screw in the magnesium anodes using a suitable span-
ner.
The two magnesium anodes are supplied in a cardboard
box on the pallet
NOTE:
Tighten to a torque of 25 Nm.
2
7000/2 1500 HV PLUS
7000/2 2000 HV PLUS
8
1
2
2
3
1
1
1
1
Advertisement
Table of Contents
