Related Manuals for Warmlite WHITBY 2KW
Summary of Contents for Warmlite WHITBY 2KW
- Page 1 WHITBY 2KW ELECTRIC FIRE INSET YOUR SAFETY & INSTRUCTION MANUAL WL45048/WL45049 PLEASE READ CAREFULLY This product is only suitable for well insulated spaces or occasional use www.warmlite.co...
-
Page 2: Technical Data
LED Display ON/OFF Switch Remote Control The images are for illustration purposes only and might not be a true indication of the actual product. TECHNICAL DATA Description: Whitby 2KW Electric Fire Inset Model: WL45048 Chrome WL45049 Brass Rated Voltage: 220-240V... -
Page 3: Disposal Of The Unit
The WEEE directive, introduced in August 2006, states that all electrical items must be recycled, rather than taken to landfill. Please arrange to take this appliance to your local Civic Amenity site for recycling, once it has reached the end of its life. www.warmlite.co... -
Page 4: Product Safety
PRODUCT SAFETY When using any electrical appliance, basic safety precautions should always be followed including the following: • Check that the voltage of the as this could create a fire hazard. main circuit corresponds with The appliance must not be the rating of the appliance located immediately below a before operating. - Page 5 • Children should not play with • In order to avoid overheating, the appliance. do not cover the appliance. www.warmlite.co...
- Page 6 • This appliance can be • Please ensure that the used by children aged appliance is used on a from 8 years and above stable, level, and heat and persons with reduced resistant surface. physical, sensory or mental • If the supply cord or capabilities or lack of appliance is damaged, experience and knowledge...
- Page 7 • CAUTION! DO NOT operate the appliance with wet hands. • DO NOT tip the appliance over as this may cause damage to the appliance and create a fire hazard. HIGH VOLTAGE HOT SURFACE DO NOT COVER www.warmlite.co...
-
Page 8: Installation
HANDLING Before continuing any further with the installation of this The heater is suitable for installation into a location that fire please read the following: has an opening size within the guidelines shown below: • Two people should be sufficient to lift the fire. Width Minimum 15 1/2”/390mm Maximum 19”/483mm... - Page 9 Press the “DATE TIME” button again, then press the “+” or “-” button to set the minute. • Press the “TIMER SET” button once again, and the • Press the “OK” button to confirm and complete. cursor on the left side of date starts blinking. www.warmlite.co...
- Page 10 • Press the “▲” or “▼”button to move the cursor CAUTION! Do not touch the fire as it will be hot. Set the to the corresponding date, press the “+” button to heater switches to OFF and leave the fire to cool down add the corresponding date, or press “-”...
-
Page 11: Troubleshooting
No light Check that the LED is working. If broken, a replacement is necessary. WARNING: DO NOT IMMERSE ANY ELECTRICAL PART OF THE APPLIANCE IN WATER SUCH AS MOTOR UNITS OR PLUGS. PLEASE SEE CLEANING SECTION FOR FURTHER INSTRUCTIONS. www.warmlite.co... - Page 12 Model Identifier(s): WL45048 & WL45049 Item Symbol Valve Unit Item Unit Type of heat input for electric storage, local Heat Output space heaters only (select one) Nominal heat Manual heat charge with integrated Pnom output thermostat Minimum heat Manual heat charge control with room Pmin 0.95 output (indicative)
- Page 13 NOTES www.warmlite.co...
- Page 14 NOTES CUSTOMER SUPPORT TEAM: +44 (0) 333 220 6056...
- Page 15 NOTES www.warmlite.co...
- Page 16 1 year. Extended warranty is only valid with proof of purchase or receipt. Your warranty becomes void should you decide to use non Warmlite spare parts. Spare parts can be purchased from www.warmlite.co...
Need help?
Do you have a question about the WHITBY 2KW and is the answer not in the manual?
Questions and answers
How do I change the bulb