Echo CS-2511P Operator's Manual page 23

CS-2511P
4. Remove guide bar (D) and saw
chain (E) as necessary.
Note: See "Maintenance"
section for Guide Bar,
Sprocket, and Setting the
Saw Chain for
maintenance procedures.
5. Mount guide bar (D) on stud (F)
and slide toward clutch drum
sprocket (G) to make saw chain
(E) installation easier. Install
saw chain around clutch drum
sprocket and guide bar as
shown, with saw chain cutters
on top of guide bar facing
forward.
Do not start or operate saw if brake band is not in place on
clutch drum. Make sure you check chain brake operation after
sprocket guard is replaced. Do not use saw if chain brake does
not function properly. Improper sprocket guard assembly can
result in serious injury, and will cause severe saw damage if unit
is started.
6. Install sprocket guard cover (C)
over guide bar studs (F). Make
sure chain tension adjuster pin
(H) fits into the guide bar
adjuster hole (J), and brake
band in sprocket guard cover
must be positioned around
clutch drum sprocket (G).
X7503333700
© 11/2020 ECHO Incorporated
DESCRIPTION
C
H
K
G
B F E D
G
J
F
C
23