Advertisement
6. Slide each of the four Wheels (C) onto
an axle with the Air Valve facing out.
Slide one 1-1/4" Washer onto each axle.
7. Attach each of the four Axle Caps to the Axles.
8. Insert the lower part of the Handle (B) into the
Steering Assembly (J). Slide the 2-5/8" Bolt into
the Assembly and through the Handle so that it
exits the other side of the Assembly. Tighten the
Bolt into place with a Small Washer and Nut Cap.
9. Turn the Wagon upright. Attach one (1) of the
Long Side Panels (E) to the wagon with the
three 1-3/4" Bolts going through both the Tray
and each vertical slat. The top of the Bolts
should be on the inside of the Tray. Tighten
each into place with a washer then a Nut Cap.
Parts List and Diagram
Part
Description
A
Tray
B
Handle
C
Wheel
D
Turntable
E
Long Side Panel
F
Short Rear Panel
G
Short Front Panel
H
Rear Axle Assembly
Rear Axle Braces
I
J
Steering Assembly
Item 60570
Qty
1
1
4
1
2
1
1
1
2
1
For technical questions, please call 1-888-866-5797.
Note: The Short Front Panel (G) is the one
with a downward curved front slat.
10. Attach the Short Rear Panel (F) to the wagon
with two 1-3/4" Bolts going through the Tray (A)
and each vertical slat. Tighten into place by
sliding on the washer followed by the Nut Cap.
11. Attach the second Long Side Panel (E) as in step 9.
Attach the Short Front Panel (G) with two 1-3/4"
Bolts. Tighten into place with the Washer
and Nut Cap as previously described.
Part
Description
K
Assembly Hardware set contains:
1-3/4" M6 Round Head Bolt Set*
2-5/8" M6 Round Head Bolt Set* (handle)
1/2" M6 Bolt Set* (axle, steering yoke)
Axle Washer
Axle Caps
1-1/8" Bolt with hole
Bolt Cotter Pin
7/8" Turntable Washer
Turntable Lock Washer
Turntable Nut
*Bolts include flat washer and nut.
Qty
-
10
1
8
4
4
1
1
1
1
1
Page 3
Advertisement
