Advertisement
Specifications
IMPORTANT SAFETY INFORMATION
Read all safety warnings and instructions.
Failure to follow the warnings and instructions may result in serious injury.
Save all warnings and instructions for future reference.
1. AGES 5 AND UP ONLY.
Do not allow younger children to use.
2. WEAR PROPER SAFETY HELMET AND
COMPLETE SAFETY GEAR WHEN RIDING.
Responsible adult must supervise during use.
Use as intended only.
Rider must stay seated at all times during use.
Do not allow more than one child
to play with tricycle at once.
3. Do not use in unstable or dangerous area.
Tipping over can cause injury.
Do not use in areas where vehicles may be present,
such as parking areas, driveways, or roads.
Assembly
Note: For additional information regarding the parts listed in the following
pages, refer to the Assembly Diagram on facing page.
Note: Do not overtighten hardware.
1. With the Tray (A) upside down so the bottom is facing
upward, place it over saw horses or sturdy cartons.
2. Attach the Rear Axle Assembly (H) to the
Tray (A) using two 1/2" Bolts. Line up the
Rear Axle Assembly with the holes located at the
very back of the Wagon. Insert the Bolt so that the
small washers, small lock washers and cap nuts
are screwed on from the underside of the wagon.
3. Slide each of the Rear Axle Braces (I) over the end
of each Rear Axle until they sit firmly to the inside
of the Rear Axle Assembly (H). Line up the end of
the Braces with the holes in the wagon. Using two
1/2" Bolts, insert the bolts from the top of the wagon
so that the small washers, lock washers and the
nut are secured on the underside of the wagon.
Page 2
Tires
Age Range
Weight Capacity
Deck Size
Inside Dimensions
Replacement Wheels
For technical questions, please call 1-888-866-5797.
10" Pneumatic
5 and up
330 lb.
33-5/8" x 15-3/4" x 5-1/2"
31-7/8" x 13-3/4" x 4"
Harbor Freight Item 30900
4. Wear ANSI-approved safety goggles
and work gloves during assembly.
5. Read manual before assembly and/or use.
6. Do not exceed 330 lb. capacity.
7. Inspect before every use;
do not use if parts loose or damaged.
Check and tighten hardware periodically.
8. Assemble completely according to instructions
before allowing a child to play with this product.
4. Attach the Turntable (D) to the Steering Assembly (J).
Attach the Steering Assembly to the Turntable using
the 1-1/8" Bolt with Hole. Slide the Bolt through the
underside of the Steering Assembly (J) and into the
Turntable (D). Secure it from inside the Turntable
with the 7/8" Washer, the Large Lock Washer and
the nut. Loosely thread the nut onto the Bolt. Insert
the Cotter Pin through the hole and spread it open.
5. Attach both parts (now one assembled unit as
shown in Step 4) – the Steering Assembly (J) and
the Turntable (D), to the Tray (A). Insert each of the
four 1/2" Bolts from the top of the wagon and tighten
it into place from the bottom of the Tray with four (4)
small washers, four small lock washers and four nuts.
Item 60570
Advertisement
