Zenoah BHT250PD60 Workshop Manual page 19

4. Put the cable through the O-ring and the fastener.
Lubricate the O-ring lightly with grease to make the
assembly easier.
5. Press the fastener onto the handle.
6. Pull out the handle stop (C) and turn one half
revolution clockwise (D) until the handle stop comes
into position.
C
7. Put the handle in the chassis and connect with the 4
screws.
620 - 002 - 29.01.2019
D
1 /
2
8. Connect the plug (A) and put the cables with clips
(B) in the chassis.
B
A
Repair instructions - 19