Maintenance And Care - Wolf WS125 18.0V Original Operating Instructions

To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Adjusting the guard
To adjust the tool to the task at hand, the
guard hood can be adjusted by 12 notches
on 360° without a tool.
CAUTION!
Risk of injury! Wear protective gloves.
Remove the battery.

Turn guard hood opposite to the

direction-of-rotation arrow on the gear
head to the required position.
Work instructions
NOTE
When the power tool is switched off,
the grinding tool continues running briefly.
Rough-grinding
WARNING!
Never use cutting-off wheels for rough-
grinding.
22
– Angle of wheel 20–40° for best cutting
performance.
– Applying moderate pressure, move the
angle grinder backwards and forwards.
As a result, the workpiece will not
become too hot and there will be no
discoloration; nor will there be any
grooves.
Cut-off grinding
WARNING!
A special cutting guard must be used for
cutting.
See manufacturer's accessories catalogue.
– The angle grinder must always be
operated backwards.
Otherwise, there is a risk of the angle
grinder jumping uncontrollably out of the
groove.
– Do not press, tilt or oscillate the power
tool.
– Adjust the feed to the material which is to
be cut: the harder the material, the slower
the feed.
For further information on the manufac-
turer's products go to www.wolff-tools.com.

Maintenance and care

WARNING!
Remove the battery before carrying out any
work on the power tool.
Cleaning
Regularly clean the power tool and

ventilation slots. Frequency of cleaning is
dependent on the material and duration
of use.
WS125 18.0V