Energy Saving Tips; Putting Into Operation - Iarp DELIGHT LITE User Instructions

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
11. OPENING THE DROP-LEAF
GLASS
To open and close the display compartment, vertically slide the drop-
leaf glass on the rear of the equipment.
Ensure perfect closure as incorrect closure would have a
negative impact on the performance of the equipment and
on the excessive build-up of ice on the inner walls.

12. ENERGY SAVING TIPS

• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and
in a position out of direct sunlight.
• Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance
causes an increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are opened and
where the appliance is placed. These factors have to be taken into account when setting the thermostat. Only open
the doors when strictly necessary.
• Let hot food and drink cool down before placing them in the appliance.
• The positioning of the shelves in the fridge has no effect on energy efficiency.
• The fridge compartment light system uses a LED light, which at the same time ensures more efficient lighting and
reduced energy consumption.

13. PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to
stand for at least three hours before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of
the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR
WILL HAVE TO BE CONNECTED IS TO BE PROTECTED BY A VERY
SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA); IT
IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or
multiple socket outlets to connect the counter.
DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught
or stepped on, away from water and the other liquids and heat sources and must not be
damaged.
In case of breakage of the power cable of the cabinet, it must be replaced by the manufacturer
or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical
regulations for the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
DELIGHT LITE
DELIGHT PRIME
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
1 7 / 6 4
PAGE
N° DOC
EQUIPMENT CLOSED
EQUIMPENT OPEN
UM000327