Mtd: Real-Time And Date - Plura SPT Operating Manual

Page 24

2.4.5.4. MTD: Real-Time and Date

•
Displaying time or date of local time zone decoded out of the MTD data.
•
Source = MTD has to be selected.
The following set-up can be done utilizing the "Display" tab (chapter "Display" Tab: Display
Mode, Brightness ...):
Choose the delimiter
This set-up determines the separating sign of the LED display:
Auto
Off
.
:
Set time or date
If enabled by configuration of the Access Rights, it is possible to set time and date.
Attention: Altering time or date will alter the most important parameters of the
system. All timers relate on the real-time. A leap in time will lead to a
jump in the time code and in the NTP time of the MTDoE central unit. All
connected units receiving a time via time code from the central MTD
generator or via NTP from the MTDoE central unit have to handle this
leap in time. Therefore, it is strongly recommended to set the access rights
to "Display" or "Off" in order to avoid unintentional operating.
During normal operating mode the central MTD generator always outputs
a correct time. If this is not true, the cause of this failure should be found
and cleared.
Enter a new value with the numerical keypad, then press START or UP. The entry of a
preset value can be cancelled by using the RESET or + or – key.
Maybe the display of the SPT does not show the corrected time at once, because it may
last up to 60 seconds until synchronization has been established.
Altering other parameters of MTD time or date – as there is time in a 12- or 24-hour format –
is part of the MTD system's configuration. Please refer to "The MTD System – Installation
and Operation Manual" to read about installation and basic set-up of the MTD system.
Automatically decoded out of the MTD status data.
No sign:
Decimal Point:
Colon:
Operating Manual SPT
Example: 23 59 59
Example: 23.59.59
Example: 23:59:59