1. Manuals
  2. Brands
  3. Plura Manuals
  4. Timer
  5. TCD-56
  6. Short operating manual

Plura TCD-56 Short Operating Manual

Time code display
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Short Operating Manual
Revision: 3.1
March 20, 2015
Time Code Display
TCD-56

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TCD-56 and is the answer not in the manual?

Questions and answers

Related Manuals for Plura TCD-56

Summary of Contents for Plura TCD-56

  • Page 1 Short Operating Manual Revision: 3.1 March 20, 2015 Time Code Display TCD-56...

  • Page 3: Table Of Contents

    Short Operating Manual TCD-56 TABLE OF CONTENTS Page A1 SAFETY INSTRUCTIONS A2 COPYRIGHT A3 CE-DECLARATION FRONT DISPLAY OPTION R = LTC READER, OPTION V = VITC READER CONFIGURATION INTERFACE (CONFIG) REAR PANEL AND SPECIFICATIONS...

  • Page 4: A1 Safety Instructions

    No part of this publication may be reproduced, translated into another language, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise without the prior written consent of PLURA Europe GmbH. Technical changes are reserved. All brand and product names mentioned herein are used for identification purposes only, and are trademarks or registered trademarks of their respective holders.

  • Page 5: A3 Ce-Declaration

    Short Operating Manual TCD-56 A3 CE declaration of conformity PLURA Europe GmbH Muehlweg 11 D-73433 Aalen herewith declare under our sole responsibility that the TCD-56 meets the intent of the following directives, standards and specifications: 73/23/EEC Low Voltage Directive EN 60950 electrical and mechanical safety ...

  • Page 7: Front Display

    Short Operating Manual TCD-56 Page 1 Front display DP3 DZ2 After power-on the display shortly indicates the revision of the firmware, then it displays the time of the time code reader. Other operating modes can be indicated by the LEDs ‘DP1’, ‘DP2’, ‘DP3’, ‘DZ2’, ‘DZ3’:...

  • Page 8: Option R = Ltc Reader, Option V = Vitc Reader

    Option R = LTC reader, option V = VITC reader TCD-56 can read time code as LTC (input XLR) and/or VITC (input BNC ‘Video In’). With both options the factory setting gives VITC the higher priority, i.e. as long as VITC can be read this time code will be displayed.
  • Page 9 Short Operating Manual TCD-56 Page 3 Video Out (Option) Composite video output (loop) Interfaces Connector Signal description RS232 interface to change the unit’s CONFIG 9-pins D-Sub female configuration. Connect to PC via straight cable. TxD (output) RxD (input) DTR (output)

Table of Contents