Operation / Accessories; Powering The Unit On / Off; Operating The Lighting; Operating The Compressor - AEG LA 10 Operating Instructions Manual

22
4.0 OPERATION /
ACCESSORIES

4.1 Powering the unit On / Off

▪ Set the On / Off switch
now operational and the manometer
is activated. The LED lights
current capacity of the storage battery.
▪ In operational mode the 12 V vehicle outlet
is powered.
▪ To switch the unit off set the On / Off switch
to ( O ).
Automatic start warning! If the
On / Off switch
power is set to ( I ) before switching the
unit on, the compressor will automatically start
and compressed air will be supplied to the com-
pressed air hose. Risk of property damage
and personal injury!

4.2 Operating the lighting

▪ Set the On / Off switch
now operational.
▪ To turn the lighting on set the lighting On / Off
switch to ( I ).
15
▪ To turn the LED lights off set the light
switch to ( O ).
▪ To power the unit off set the On / Off
switch to ( O ).
13

4.3 Operating the compressor

The unit can be operated with the built-in storage
battery or the built-in 12 V vehicle plug.
to ( I ). The unit is
13
lighting
1
indicate the
20
16
13
for compressor
19
to ( I ). The unit is
13
Attention! Always wear suitable ear
protectors and safety goggles during
operation!
Check the unit and compressed air hose
damage before every use! Do not operate dam-
aged units! Review the manufacturer instructions
for the item to be inflated before every use.
Select the appropriate valve adapter (e.g.
Open the valve quick disconnect
the quick disconnect lever away from the com-
pressed air hose . Now attach the valve
3
adapter and press the lever toward the com-
pressed air hose to close it (see Image 5).
4
Image 5
Automotive, motorcycle- and bicycle tyres with
automotive valve (Schrader valve with 7.7 mm
thread diameter) can be inflated without adapter!
Do not operate the compressor for more
than 10 minutes. After this time allow the
unit to cool down for 10 minutes!
▪ No valve adapter required to inflate car tyres.
First remove the cap from the tyre valve.
▪ Open the quick disconnect
automotive valve plug as far as possible onto the
tyre valve. Close the valve quick disconnect
when doing so.
▪ Verify the automotive valve lever plug is firmly
attached to the tyre valve by carefully pulling on
it.
for
3
7
by pressing
4
7
3
and attach the
4
).