BRC Alta Operation

Alta
Digital Handset Operation
The table must be initialized when installed or when components are replaced. This must be done
prior to operating the table for normal use.
Step Operation
1. Initialization procedure 1 Press and hold ▲&▼simultaneously
Step Operation
more than 3 seconds
1 Press and hold ▲&▼simultaneously
2 Keep pressing ▲&▼
more than 3 seconds
2 Keep pressing ▲&▼
3 Release ▲&▼ together
3 Release ▲&▼ together
The initialization procedure must be completed before the first running after table is
installed or parts replaced
The initialization procedure must be completed before the first running after table is
2. Move table up & down
installed or parts replaced
Step Operation
1 Press and hold ▲
Step Operation
2 Release ▲
1 Press and hold ▲
3 Press and hold ▼
2 Release ▲
4 Release ▼
3 Press and hold ▼
4 Release ▼
3. Set handset memory position
Step Operation
1 Press and hold ▲ or ▼，then
Step Operation
release
2 1 Click button S, then click button 1 or 2 Press and hold ▲ or ▼，then
release
or 3 within next 3 seconds
2 Click button S, then click button 1 or 2
or 3 within next 3 seconds
4. Operation of stored memory positions
Step Operation
1 Press and hold the button 1 or 2 or 3
Step Operation
1 Press and hold the button 1 or 2 or 3
5. Change handset display from centimeter to Inches
Step Operation
1 Press and hold button S, then press
Step Operation
1 Press and hold button S, then press
BRC Group |
24 Armstrong Ave, Georgetown, ON L7G4R9 | 877-260-4309 | www.brc.group
MEMORY
1 2
UP
Motion
Legs begin to move down at a half speed of normal operation
Motion
Legs begin to move down at a half speed of normal operation
Legs move down to the lowest position and rebound 2-5 mm,
then stop
Legs move down to the lowest position and rebound 2-5 mm,
Initialization is completed
then stop
Initialization is completed
Motion
Legs move up
Motion
Legs stop
Legs move up
Legs move down
Legs stop
Legs stop
Legs move down
Legs stop
Motion
Run the legs to the position you want the table surface to be
Motion
Position 1 or 2 or 3 is saved Run the legs to the position you want the table surface to be
Position 1 or 2 or 3 is saved
Motion
Legs return to the corresponding position saved
Motion
Legs return to the corresponding position saved
Motion
The height information will be changed between centimeters
Motion
The height information will be changed between centimeters
DISPLAY
29.0
DOWN
MEMORY
3 S
SET
2019 R1
1