Operating Mode - FDS MLED-CTRL Box User Manual

MLED-CTRL Box
Display with 3 x MLED panels (MLED-3C):
Zone A: 8-9 characters, height 14-16cm depending on the font type selected
Zone B - C: 16 characters per zone, height 7cm
Zone D - G: 8 characters per zone, height 7cm
Zone H - I: 4 characters per zone, height 14-16cm
Display with 2x6 MLED panels (MLED-26C):
Zone A: 8-9 characters, height 28-32cm depending on the font type selected
Zone B - C: 16 characters, height 14-16cm per zone
Zone D - G: 8 characters, height 14-16cm per zone
Zone H - I: 4 characters, height 28-32cm per zone

2. Operating Mode

Seven operating modes are available:
1) User Control via RS232
2) Time / Date / Temperature
3) Start-Finish
4) Speed trap
5) Counter
6) Count-Down
7) Start Clock
Modes can be selected and configured either via our iOS or PC setup application. The first two
modes are part of the basic firmware. Modes 3 - 6 belong to a 1
activation key to operate. Mode 7 belongs to a 2
Modes 2-7 are optimized for MLED-3C and MLED-26C configuration.
2.1. User Control Mode
This is the general display mode for which you can send data from your own preferred
software. Information can be displayed using either the RS232/RS485 port (using FDS / TAG
Heuer protocol) or via Bluetooth using our iOS application.
This is the only mode giving full access to the display zones described in chapter 1.2.
2.2. Time / Date / Temperature Mode
Alternating time, date and temperature, all controlled via GPS and external sensors. Each of
which can be pre-defined colors selected by the user for optimum and eye-catching visual
impact.
The user can choose between Time, Date and Temperature or a mix of all 3 options scrolling
consecutively depending on the user selection.
August 2020 - Version EN 1.1
www.fdstiming.com
st
optional group and require an
nd
optional group which also requires activation.
User manual