2.2
Faults and Troubleshooting
The equipment runs through regular quality controls during production. Nevertheless, errors
or malfunctions on the equipment may occur. Individual parts are often the cause of faults and
replacement is usually sufficient. Please use the following overview to see the six most common
errors and how to repair them. If the equipment still does not work properly, please contact your
contract partner.
Problem
Cause
Squeaking &
Loose or too tight screw
cracking noises
connection
2.3
Maintenance and service calendar
The equipment needs to be cleaned after every training session with a moist towel (no solvent!)
in order to avoid damage caused by sweat.
The following routine work must be done in the specified time intervals:
Part
Check screws
Weekly
Monthly
Solution
Check or lubricate screw connection
Annually
I
9