Advertisement
3.2 Product photo
Fig. 1: ESM programming unit with protective cover and connector cable
4. COMMISSIONING AND OPERATION
4.1 Connecting ESM programmer to fan
CAUTION
Electrical charge on the unit
Risk of injury
> Before programming, disconnect the fan from the power supply.
> Open the cap on the fan, see Figure 2.
> To do this, use a broad flat-blade screwdriver.
> Turn the cap a quarter of a turn counter-clockwise.
NOTE
Sealing damage to the fan
The cap could be damaged and the fan is not sealed properly
> Turn the cap only for one-quater turn when opening or closing.
Fig. 2: Opening the cap
Connecting the ESM programmer
The connection on the ESM programmer is located on the top of the unit, see
Figure 3.
> Plug the RJ45 connector into the matching socket.
Be sure that the connector clicks into place, otherwise there may not be a proper
connection.
Connector cable
On/Off button
Display
Navigation
Connector for fan
Fig. 3: Connecting the ESM programmer
Connecting the fan
The black connector is intended as the connection to the fan.
> Plug the connector into the socket according to its coding, see Figure 4.
> Plug the connector so far into the socket that the flat part of the connector
completely disappears in the opening.
> Make sure that the connector is not tilted when you do this. Never use force to
plug in the connector.
Fig. 4: Connecting the fan
4.2 Programming
4.2.1
> Switch the ESM programmer on by pressing the "On/Off" button and holding it
until a tone is emitted.
The message "ESM PROGRAMMER – POWER ON" appears briefly before
the ESM programmer changes to the main menu, to "CHANGE SPEED 1".
The ESM programmer is now ready for use.
4.2.2
The following options are available in the main menu:
- CHANGE SPEED 1
- CHANGE SPEED 2
- BACKLIGHT
- BATTERY
- VERSION
Switching the unit on
Main menu
Advertisement
