Table of Contents
Advertisement
(1)
Be sure the specified adaptor is used; otherwise this device would work
improperly or even be damaged.
(2)
Be sure this device is setup in place; otherwise it would result in communication
fault.
(3)
Be sure the communication line is connected to the correct interface; otherwise
it would result in communication fault.
(4)
After connection, lines should be protected with insulating tape to avoid
oxidation and short circuits.
(5)
Risk of explosion if battery is replaced by an incorrect type,dispose of used
batteries according to the instructions.
(6)
Normal working conditions for BACnet gateway：
① Temperature : 0~55℃;
② Humidity: less than 85%,except for the condensation of dew;
③ Location: indoor (it is highly recommended to install this product in the
electric control cabinet), not subject to direct sunlight, rain and snow etc.
(7)
Graphics in the instruction manual are for reference only.
(8)
Before energizing BACnet gateway, the unit shall be in energizing status, and
normal communication between units.
(9)
For the first time energizing BACnet gateway, enter the gateway configuration
page settings, restart the gateway after setting up, and operation gateway after wait
for 10 minutes(Generally, it is related to the number of units. The more units, the
longer the time).
CAUTION!
Advertisement
Table of Contents
