Table of Contents
Advertisement
EN
Track Setup
Set up vertical timing gate(s) on an outside section of the track, facing outward
across the track. Pointing the IR LEDs toward the center of the track may cause
incorrect lap timing readings.
Additional timing gates may be set up along the track at intervals to defi ne lap
segments. Up to 9 lap segments may be added in addition to the fi nish line gate.
When fi rst powered up, the 7 segment display will show your current voltage in
single digits, starting with the fi rst digit.
For example: If the battery voltage is 11.54V, it will fi rst display 1,
then fl ash and show the second digit 1, then the third digit 5, and then the
fi nal digit 4.
After the voltage is shown, the display on the base unit will alternate between
the Gate number and Power Level. Power Level is designated by an illuminated
decimal point. No decimal indicates the Gate number. When the display is
alternating between the Gate and Power settings, the base unit is in normal
operation mode.
Press and hold the button to enter the settings menu and change between
menu points. When the numbers displayed are solid, the base unit is in the
settings menu. Use a short press to change values. To save settings and exit
back to the normal operation mode, press and hold the button.
The Gate can be set for the gate number to defi ne the start/fi nish gate and lap
segments. Up to 10 gates can be used. The Start/Finish gate is 0.
Add up to 9 more SPMLTG5000 gates, with each segment set to their own
number.* Lap segments are indicated in numerical order:
The Power Level can be adjusted to suit the environment.
• Bright sunny days will need high Power Level settings
• Indoor settings will need lower settings.
TIP: Turn the Power Level up for missed timing, turn the Power Level down if
the system is triggering the timer when it shouldn't.
* RPM based timing can only support the start/fi nish gate, and cannot support
additional timing gates for lap segments.
6
Advertisement
Table of Contents
