Belkin F5D7230-4 Supplementary Manual page 3

4. Connect power to your AP. Make sure the AP is on and proceed to the next step.
5. From a computer already connected to your router, access the Advanced Setup Utility
by opening your browser. In the address bar, type in "192.168.2.1" do not type in
"www" or
address, use that IP address.
6. You will see the router's user interface in the browser window. Click "Wireless Bridge"
(1) on the left-hand side of the screen. You will see the following screen.
(2)
(1)
(3)
7. Check the box that says "Enable ONLY specific Access Points to connect"
8. In the field named AP1,
have typed in the address, click "Apply Changes".
9. Bridging is now setup.
http:// before the number. Note: if you have changed your router's IP
(3) type in the MAC address of your secondary AP. When you
(2)