Adjusting The Cutting Height; During Operation; Starting The Machine - Toro Flex-Force Power System 21466 Operator's Manual

Adjusting the Cutting Height

WARNING
Adjusting the height-of-cut could bring your hands into contact with a moving blade and
result in serious injury.
• Shut off the motor, remove the battery, and wait for all moving parts to stop before adjusting
the cutting height.
• Do not put your fingers under the housing when adjusting the cutting height.
Adjust the cutting height as desired. Set all wheels to the same cutting height

During Operation

Starting the Machine

1. Ensure that the battery pack is installed in the machine; refer to
2. Insert the electric-start button into the electric-starter switch (A of
3. Squeeze the blade-control bar and hold it to the handle (B of
4. Press the electric-start button and keep it pressed until the motor starts (C of
Figure 9
Installing the Battery Pack (page
Figure
Figure
13
(Figure 9).
10).
10).
Figure 10).
g254131
12).