Related Manuals for Autojack TJ250
Summary of Contents for Autojack TJ250
- Page 1 SAFETY AND OPERATING MANUAL TROLLEY JACK TJ250 ORIGINAL INSTRUCTIONS Made in China 160120 Version 1 TJ250...
-
Page 2: Table Of Contents
TABLE OF CONTENTS Safety Precautions………………………….………………………………………01 Machine Details……………………………………………………………………..03 Operation……………………………………………………………………………….04 Maintenance………………………………………………………………………..06 Troubleshooting……………………………………………………………………..07 Declaration of Conformity………………………………………………………09 Parts list ………………….…………………………………………………………….10 Parts Diagram…………………………………………………………………………11 TJ250... -
Page 3: Safety Precautions
- Place jack under lifting points recommended by vehicle manufacturer (see vehicle hand book). Ensure lifting point is stable and centred on Saddle. - NO RESPONSIBILITY IS ACCEPTED FOR INCORRECT USE OF THIS PRODUCT. TJ250... - Page 4 DO NOT allow untrained persons to operate the jack and DO NOT use the jack for purposes other than which it is designed. DO NOT allow persons to ride on the jack. When not in use store the jack, fully lowered, in a safe, dry, childproof area. TJ250...
-
Page 5: Machine Details
2. Pump handle socket 3. Floor Jack frame Max. Saddle height - 515mm 4. Pump handle hex bolt 5. Pump system Length - 722mm 6. Castor wheel Weight - 34.1KG 7. Fixed wheel 8. Saddle 9. Lifting arm load:360-515mm TJ250... -
Page 6: Operation
It is recommended that this Attachments & Adapters. inspection be made by a Only attachments and/or adapters manufacturer’s or supplier’s supplied by the manufacturer shall be authorised repair facility. used. TJ250... - Page 7 4. Turn the release valve slowly e. Be sure that the vehicle and the jack are on a hard, level surface. counter clockwise to lower the vehicle onto the ground. TJ250...
-
Page 8: Maintenance
5. Replace oil filler plug. Then replace the unit force on saddle the if necessary. cover. 6. Carefully and slowly pinch the oil filler plug to release pressurised air. 7. Repeat above steps until trapped air is completely vented. TJ250... -
Page 9: Troubleshooting
TROUBLESHOOTING Problem Possible Cause Remedy 1) Be sure to use jack the with 1) Overloaded. Jack will not lift the load. adequate capacity. 2) Oil level low. 2) Top up oil level. 3) Release valve not 3) Check and close release correctly closed. - Page 10 6) Jack spring damaged or 5) Check and fully open release unhooked. valve. 6) Replace spring or contact local service agent. Jack does not lower at all. 1) Release valve closed. 1) Check and fully open release valve. TJ250...
-
Page 11: Declaration Of Conformity
TJ250... -
Page 12: Parts List
Shoulder bolt M18x54mm T825011BCL-2 Cover plate GB845 Socket head cap screw Position shaft T84004-7 Rubber sleeve GB859-8 Spring washer M8 GB823- M8X16 Pan head combination drive machine screw M8X16mm T830018Z.2a Handle assembly T83508.5-4 Handle lock pin T830026.MF Seal kit EP82-3 TJ250... -
Page 13: Parts Diagram
PARTS DIAGRAM EP82-3 TJ250...
Need help?
Do you have a question about the TJ250 and is the answer not in the manual?
Questions and answers