Page 1
Important: This device can improve the vehicle safety level, but could not prevent the vehicle from stolen or the occurrence of unexpected accidents. EASYGUARD Electronics will not be liable for any resulting from the damage of this product cause by direct or indirect losses.
Once you find correct wires, please solder them well or use crimp connectors to connect them together to avoid the possibility of them becoming disconnected and causing the unit to fail. If there are any 16.Emergency disarm & start the car questions, please contact EASYGUARD authorized dealer or contact EASYGARD electronics directly for 17.Programming method help.
The following precautions are the sole responsibility of the user; however, authorized their warning lights after they lose power. Disconnecting the battery requires this code to be erased, EASYGUARD Electronics dealers should make the following recommendations to all users of this which can require a trip to the car dealer.
Page 5
2 wire The 2nd Row 5-pin wire harness 5.If there are 2 ACC wire in your ignition harness, connect both ACC wires with blue ACC wire in ec003 White Unlock control wire(-300mA) Type B, see central door locking connection 6.If there are 2 starter wires in your ignition harness, connect both starter wires with yellow starter wire...
Page 6
Note 10 Using a window closer module with EC003 To use a window closer module with EC003, connect the module to the white/black lock control wire on EC003 . Note 11 Wiring method for fuel pump wire The fuel pump wire is connecting with fuel pump or oil pump wire. If you can't find this wire in your car, please connect it with constant 12V wire or tach wire in your car.
18 minutes feature. D.If you connect the foot brake wire from EC003 with constant 12V wire in your vehicle, or when you're in PKE induction range, you can't use remote engine start function.
EC003 with your car locking and unlocking wire directly, or follow with the Type B negative trigger as below diagram shows to connect with the car central door locking system.
Please refer to note 9 GWR (Ground while running) (-) wire connection 5.How to connect a window closer module with your alarm? If there is window closer module need to connect with EC003 alarm, connect the wire from window closer module with white/black locking wire in central door locking wire.
Need help?
Do you have a question about the EC003 and is the answer not in the manual?
Questions and answers