Download Print this page

Musicmakers CIGAR-BOX UKULELE KIT Quick Start Manual

Advertisement

Quick Links

CIGAR-BOX UKULELE KIT
PARTS LIST:
Cigar Box
Pre-cut String Board
Set of 4 Strings
4 Geared Tuners
16 Tiny screws for gears
Plastic Nut
Plastic Bridge
20 Flat Toothpicks
Flatpick
2 Wood Screws, 3/4"
2 Cup Washers
Assembly Instructions
MUSICMAKERS
PO Box 2117
Stillwater, MN 55082
6 5 1 - 4 3 9 - 9 1 2 0
w w w . h a r p k i t . c o m
TOOLS & SUPPLIES
YOU WILL NEED:
Elmer's Wood Glue
Damp Rag
Pencil
Sanding Block (100 grit)
Wire Cutter
Screwdriver
Drill

Advertisement

loading
Need help?

Need help?

Do you have a question about the CIGAR-BOX UKULELE KIT and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Musicmakers CIGAR-BOX UKULELE KIT

  • Page 1 CIGAR-BOX UKULELE KIT PARTS LIST: TOOLS & SUPPLIES YOU WILL NEED: Cigar Box Pre-cut String Board Elmer’s Wood Glue Set of 4 Strings Damp Rag 4 Geared Tuners Pencil 16 Tiny screws for gears Sanding Block (100 grit) MUSICMAKERS Plastic Nut...
  • Page 2 Tape Ukulele Fret THE STRING BOARD both cut paper pattern Chart ends to keep Time required for assembling the string board (steps 1-8): pattern approximately 30 minutes from moving. 1. Use the Pattern Sheet at left to determine the location of each fret.
  • Page 3 7. Dressing the frets: It is important to have all the frets level across the tops. Use your sand gently sanding block to GENTLY sand the tops of the frets, just enough to make sure they all get touched by the sandpaper. Take care not to break any frets off, or sand them down to nothing! string board 8.
  • Page 4 12. Thread the other end of the string through wind the strings Ukulele the correct tuning pin, leaving some slack in downward on the post the wire so it wraps around the post as you turn Tuning the button. We like to have the strings wrap over the inside of the posts, as shown below, so they don’t get in the way of each other.