Advertisement
H2 HYDROGEN INHALATION SYSTEM
CONTROL PANEL
Water Level
Stop/Start
Indicator
Stop/Start
USING THE TDS MONITOR
This machine is meant to be used with water that is under 3 TDS (Total
Dissolved Solids). We recommend using distilled water. To test your water,
remove the bottom cap of the TDS pen, turn the pen on, and place the end in
the water for at least ve seconds. If the number is higher than 3, you should
replace it with lower TDS water.
BREATHING INSTRUCTIONS
This system produces a steady stream of 99.999% pure hydrogen at 600ml/
minute. In addition, it can produce a steady stream of 99.999% pure oxygen at
300ml/minute. The total combined ow is 900ml/minute.
This machine provides two options:
A. Breathe pure hydrogen
B. Breathe a combination of pure hydrogen and oxygen. Hydrogen
and oxygen combined is referred to as Brown's Gas. The combination is
66% hydrogen and 33% oxygen.
1. Connect the power cord to the machine, then plug the cord into your outlet.
Do not run the unit without water inside.
Time Display
Time Setting
Reset
4
H2 HYDROGEN INHALATION SYSTEM
2. Open the lid of the water tank lling port, add 1.5-1.9L of under 3 TDS
puri ed or distilled water, and close the lid. Do not exceed the highest water
level or use less than the lowest water level.
3. Allow the machine to stay o for 30-60 minutes.
BREATHING HYDROGEN:
4A.
lid with the lid with holes in it. Remove the cap from the hydrogen port. Attach
the Hydrogen Cannula to the hydrogen port. Leave the cap on the oxygen port.
Place the cannula on your head with the prongs inside your nose.
BREATHING HYDROGEN & OXYGEN:
4B.
oxygen, use the solid lid and remove the caps from the hydrogen and oxygen
ports. Attach the H2/O2 Outlet Cannula to both ports. Place the cannula on
your head with the prongs inside your nose.
5. Turn on the power switch. The initial time is 000 minutes.
A. This model has one production mode, High. Press Time to set the timer
for 10-180 minutes. Press Start. You can press the Start button any time to
pause or unpause the timer. To reset, simply press the Reset button.
6. When the machine starts, the gas will begin to ow after 30 seconds.
7. After use, unplug the machine.
This system will allow you to drink hydrogen-rich water. To do this, set up the
machine as you would to breathe hydrogen. Instead of attaching the cannula,
attach the tubing with bubbling stone to the hydrogen port. Place the other end
of the tubing into a vessel of water. Bubbling stone should be in the water.
Turn on the power switch. The initial time is 000 minutes. Press Time to set the
timer for 15 minutes and press Start. You can press the Start button any time to
pause or unpause the timer. To reset, simply press the Reset button.
When the machine starts, hydrogen will begin to ow after 30 seconds.
When the timer is done, turn o the machine and unplug it. Drink your hydrogen
water within a short period of time.
If breathing hydrogen, replace the solid
If breathing hydrogen and
DRINKING INSTRUCTIONS
5
Advertisement
