Download Print this page

Promolife H2 Manual page 3

Hydrogen inhalation system

Advertisement

H2 HYDROGEN INHALATION SYSTEM
DRAINING/CLEANING INSTRUCTIONS
1. If you don't plan to use the machine often or simply need to replace the water,
you will need to drain the unit. Prepare a container to drain the water into.
2. Insert the drain pipe into the drain until you hear a click. The water will
automatically drain from the drain pipe.
3. Use a clean towel to wipe the surface. Do not use volatile chemical solvents to
clean.
TROUBLESHOOTING
General Notes: If there is abnormal noise, smells or smoke, cut o the power
immediately and stop using the machine.
No hydrogen production/gas path leakage: Check the following: Whether the
hydrogen outlet pipe is leaking; whether the hydrogen outlet pipe is broken or
blocked; whether the liquid level is below the minimum limit; or if there is an
obvious air leak. Contact Promolife for instructions.
Display does not light up/low hydrogen ow: Check to make sure the power
cord is properly connected at both the machine and the outlet. If it is, contact
Promolife for assistance.
If you have any other issues: Feel free to contact Promolife for more speci c
troubleshooting.
6
H2 HYDROGEN INHALATION SYSTEM
Place the machine upright on a level surface.
Do not turn on the machine without water inside.
Do not place the machine in direct sunlight.
Drain the unit every 7-15 days.
Do not use volatile chemical solvents to clean the machine.
Do not use a power supply rated for less or more than the
power requirements of the unit.
When the unit will not be used for some time, drain
remaining water and unplug it.
When used with other electrical appliances, the devices
should be more than 30cm apart to avoid interference.
Water Inlet
Display
Water Level Indicator
H2
A diagram of the control panel and its functions can be found on the next page.
SAFETY READ BEFORE USE
Stop/Start
Reset
Time Input
O2
On/O
3
Note: When the machine is not
used for a long time, ll it with
water and start it at least once
a month for 30 minutes each
time.
Water Inlet
Heat Sink
Drain
Vent
Power

Advertisement

loading