Installation; Mains Connection; Audio Connections - Behringer 1002 User Manual

XENYX 502/802/1002/1202
tions (0 dB). Then use the TRIM controls to increase the input
amplification until signal peaks show 0 dB on the level meter.
When recording to digital recorders, the recorder's peak meter
should not go into overload. While analog recorders can be
overloaded to some extent, creating only a certain amount of
distortion (which is common and often desirable), digital recorders
distort quickly when overloaded. In addition, digital distortion is
not only undesirable, but also renders your recording completely
useless.
+ The peak meters of your XENYX display the level virtu-
ally independent of frequency. A recording level of 0 dB
is recommended for all signal types.
3.

Installation

3.1

Mains connection

AC POWER IN
Connect the power supply to the 3-pin mains connector on the
rear of the console. Use the AC adapter supplied to connect the
console to the mains. The adapter complies with all applicable
safety standards.
Please use only the power supply unit provided with
+
the console.
+ Never connect the XENYX to the power supply unit
while the latter is connected to the mains! First connect
the console to the power supply unit, then connect the
power supply unit to the mains.
Please note that both the power supply unit and the
+
mixing console heat up considerably during operation.
This is completely normal.
3.2

Audio connections

You will need a large number of cables for different applications.
The illustrations below show how the connectors should be wired.
Be sure to use only high-grade cables.
Please use commercial RCA cables to connect the 2-track inputs
and outputs.
You can, of course, also connect unbalanced devices to the bal-
anced inputs/outputs. To do this, use either mono plugs or stereo
plugs with the ring and sleeve bridged (pins 1 and 3 in the case
of XLR connectors).
Caution! Never use unbalanced XLR connectors (PIN
+
1 and 3 connected) on the MIC input connectors when
using the phantom power supply.
Fig. 3.1: XLR connections
8
Fig. 3.2:
Fig. 3.3:
Fig. 3.4: Stereo plug for headphones connection
Installation
1/4" mono plug
1/4" stereo plug