Filtration System - Kerstar Prima Operating Instructions Manual

ENGLISH
GB
4. Access to Paper Bag and Filter
a) To remove the motor head, unclip both clips. Ensure that the clips are hinged clear of the rim of
the motor head. Lift the motor head clear of the bottom can.
b) To refi t the motor cover head align the head so that the switch and cable entry lie directly opposite
the hose entry on the can. Locate the clips over the rim of the motor head and fi rmly press down
both clips until they have locked into position.
5. Cleaning Tools and Suggested Uses
a) Combination Carpet/Hard Floor Nozzle:- This nozzle is normally used only in conjunction with
the two stainless steel wands for the cleaning of carpets and hard fl oor surfaces. With the bristles
in the down position hard fl oors (wood, vinyl, concrete, etc) and the short pile carpets (corded and
carpet tiles) can be cleaned. With the bristles in the up position longer pile carpets (foam backed
and carpets with underlay) can be cleaned.
b) Crevice Nozzle:- Used to concentrate the suction power and reach into awkward places.
c) Dusting Brush:- Used for dusting skirting boards, ledges, cills, walls, etc.
d) Upholstery/Stair Nozzle:- Used for stair cleaning, car cleaning, upholstery and curtains etc. Suction
power may need to be reduced when cleaning curtains and loose fabrics.
e) Double Taper Tube:- To connect any of the accessories directly to the hose without using the
stainless steel bent hose end. Useful in confi ned areas.

FILTRATION SYSTEM

This Vacuum Cleaner is fi tted with 2 stages of fi ltration. Both stages are on the negative pressure
(Suction) side of the motor.
1) 1st Stage – K1 Disposable Paper Bag
It is very important that a paper bag be used at all times, failure to do so could result in a blocked fi lter
and over heating of the motor (leading to motor failure).
2) 2nd Stage – Cloth Filter Assembly
A cloth/nylon type of material fi lter supported by a fi lter frame. Specially designed material for use
as a Vacuum Cleaner fi lter.
6