Wireless Subwoofer Connection - LG SL8YG Service Manual

WIRELESS SUBWOOFER CONNECTION

LED indicator of wireless subwoofer
LED Color
Green
The connection is trying.
(Blink)
Green The connection is completed.
The wireless subwoofer
Red is in standby mode
or the connection is failed.
Off The power cord of wireless
(No display) subwoofer is disconnected.
Setting up the wireless subwoofer
for the fi rst time
1. Connect the power cord of the sound bar and the
wireless subwoofer to the outlet.
2. Turn on the sound bar. The sound bar and the
wireless subwoofer will be automatically connected.
- Pairing is completed. The green LED on the rear
of the wireless subwoofer turns on.
Manually pairing wireless subwoofer
When your connection is not completed, you can
check red LED on the wireless subwoofer and the
wireless subwoofer does not make sound. To solve
the problem, follow the steps below.
1. Press Pairing on the rear of the wireless subwoofer.
- The green LED on the rear of the wireless
subwoofer blinks quickly. (If the green LED does
not blink, press and hold the Pairing)
2. Turn on the sound bar.
3. Pairing is completed.
- Pairing is completed. The green LED on the rear
of the wireless subwoofer turns on.
Status
Pairing
1-7
Note :
• It takes a few seconds (and may take longer) for the
main unit and the subwoofer to communicate with
each other and make sounds.
• The closer the main unit and the subwoofer, the
better sound quality. It is recommended to install the
main unit and the subwoofer as close as possible
and avoid the cases below.
- There is a obstacle between the main unit and the
subwoofer.
- There is a device using same frequency with this
wireless connection such as a medical equipment,
a microwave or a wireless LAN device.
- Keep the sound bar and the subwoofer away from
the device (ex. wireless router, microwave oven,
etc.) over 1m (3.3 ft) to prevent wireless
interference.
Copyright © 2019 LG Electronics Inc. All rights reserved.
Only for training and service purposes.