Advertisement
HAND PUMP USER INSTRUCTIONS
Inflating the AirTrack: Remove the AirTrack from the carrying case and roll out fully so that
the valves are visible. Depending on the model, the AirTrack can have one or two valves; if
there are two valves, you can use either to inflate or deflate the AirTrack. Only use the pump
that is included with the AirTrack.
Open valve cover (1). Ensure that the valve button is in the up-position (2). Place the
head of the pump tube into the valve and twist to the right so that the pump and valve
connect tightly (3).
Recommended pressure for AirTrack is 5-6 PSI. The bounciness of the AirTracks
depends on how much pressure you put in it. Our recommended pressure level is 5-6
PSI but the most optimal pressure depends on the users' preferences. Pump until the
desired air pressure level is seen on the pump's air pressure meter. Remove the head
of the pump tube by twisting to the left. Put the valve cover back in place. Ensure
that the valve cover is properly in place to avoid air leaking from the AirTrack.
Deflating the AirTrack: Push the valve button into the down-position and the valve will open (2).
If air leaks around the valve, follow these steps:
1.
Remove the valve key from its packing case.
2. Open the valve cover and place the valve key in the valve.
3. Turn the valve key clockwise until there is no space
between the valve and the AirTrack. Do not turn
the key counterclockwise as this will cause the valve
to loosen, leak air, and eventually detach from
the AirTrack.
4. Close the vent and check to see if the leak stopped.
1
2
3
Advertisement
