Technical Specifications; Battery Charging - Hausmann PT100117 Manual

TECHNICAL SPECIFICATIONS

Lithium-ion impact drill
Rated voltage
No-load speed:
Max. torque screw diving application
according to ISO 5393
Max. screw dia.
Max. drilling diameter:
Chuck clamping range
Charging time
ASSEMBLY

Battery Charging

Only use the battery chargers are matched to the lithium ion battery of your
power tool.
Slide the battery towards at the charger as shown (Pic.D)
The Li-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by
means of a protective circuit: The inserted bit no longer rotates.
WARNING! Do not continue to press the On/Off switch after the machine
has been automatically switched off. The battery can be damaged.
The battery is supplied partially charged. Completely charge the battery before
using your power tool for the first time. The lithium ion battery can be charged at
any time without reducing its service life. Interrupting the charging procedure
does not damage the battery.
To remove the battery, press the battery unlocking button and pull the battery out
of the power tool toward the rear. (Pic.E)
The battery is equipped with a NTC temperature control which allows charging
only within a temperature range of between 0°C and 40°C. A long battery service
life is achieved in this manner.
Observe the notes for disposal.
22
PT100117
18V
-1st gear 0-400 RPM
-2nd gear 0-1400 RPM
45Nm
5/16'' (8 mm)
-Steel 1/2'' (13 mm)
1'' (25 mm)
-Wood
13/32 - 1/2'' (1 - 13 mm)
1 hour
!
!