Hausmann PT100117 Manual page 21

ADDITONAL SAFETY WARNINGS
1. Specific safety rules
1) Secure the workpiece. A workpiece clamped with clamping devices or in a
vice is held more secure than by hand.
2) Do not work with materials containing asbestos. Asbestos is considered
carcinogenic.
3) Take protective measures when potentially harmful dust (combustible
or explosive) can develop during working . Example: Some dusts are
regarded as carcinogenic. Wear a dust mask and work with dust/chip
extraction when connectable.
4) Keep your workplace clean. Certain blends of materials are particularly
dangerous. Dust form light alloys can burn or explode.
5) Always wait until the tool has come to a complete stop before placing
it down. The inserted bit can jam and lead to loss of control over the power
tool.
6) Before any work on the tool (e.g., maintenance, bit change, etc.) as
well as during transport and storage, set the rotational direction
switch to the centre position. Unintentional actuation of the On/Off switch
can lead to injuries.
7) Do not open the battery. Danger of short circuiting.
8) Protect the battery against heat, and continuous sun irradiation and
fire. There is danger of explosion.
9) Do not short-circuit the battery. There is danger of explosion.
10) In case of damage and improper use of the battery, vapours may be
emitted. Provide fresh air and seek medical help in case of
complaints. The vapours can irritate the respiratory system.
11) Use appropriate detectors to determine if utility lines are hidden in the
work area or call the local utility company for assistance. Contact with
electric lines can lead to fire and electric shock. Damaging a gas line can
lead to explosion. Penetrating a water line causes property damage or may
cause an electric shock.
12) Switch off the power tool immediately when the inserted bit jams. Be
prepared for high reaction torque that can cause kickback. The bit
insert jams when:
—the power tool is subject to overload or
—the bit becomes wedged in the workpiece.
13) Hold the tool only by its insulated gripping surfaces, when performing
an operation where the cutting tool may run into hidden wiring.
Contact with a "live" wire will make exposed metal parts of the tool "live"
and shock the operator.
14) Hold the tool with a firm grip. High reaction torque can briefly occur while
driving in and loosening screws.
2. Important safety instructions for charger and battery pack
1) Before using the charger, read all instructions and cautionary markings on
the charger and battery pack as well as the instructions on using the battery
pack.
2) Only charge your batteries indoors as the charger is designed for indoor
use only.
3) DANGER. If the battery pack is cracked or damaged in any other way, do
not insert it in the charger. There is a danger of electric shock or
electrocution.
4) WARNING. Do not allow any liquid to come into contact with the charger.
There is a danger of electric shock.
19