Related Manuals for Bavis BavSonic One on One Audio System
Summary of Contents for Bavis BavSonic One on One Audio System
- Page 1 201 Grandin Road Maineville, Ohio 45039 (513) 677-0500 BavSonic One on One Audio System Installation and Service Manual Copyright 2014 E. F. Bavis & Associates, Inc. Revised: 09/09/2014 All Right Reserved PN: 00632011...
-
Page 3: Table Of Contents
BavSonic™ One on One Audio Table of Contents Safety Instructions .......................1 Features ..........................2 Installation ...........................3 Adjustment ...........................4 Diagram Fig.1 ........................5 Troubleshooting ........................6 Installation and Service Tool List ..................7... -
Page 5: Safety Instructions
Important Safety Instructions 1. READ THESE INSTRUCTIONS 2. KEEP THESE INSTRUCTIONS 3. HEED ALL WARNINGS 4. FOLLOW ALL INSTRUCTIONS 5. DO NOT USE THIS APPARATUS NEAR WATER 6. CLEAN ONLY WITH A DRY CLOTH 7. DO NOT BLOCK ANY VENTILATION OPENINGS. INSTALL IN ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS 8. -
Page 6: Features
BavSonic™ One on One Audio Power requirements: (1) outlet providing 120Vac, 60Hz, 13w The BavSonic™ One on One audio system lets one inside position talk to one remote position. Features Full duplex operation Electret condenser microphone Proprietary closed back speaker for maximum efficiency and minimum feedback. ... -
Page 7: Installation
Installation Console: The console is designed to sit on the counter top. There is one console per lane with the speaker facing backward. The power comes from a UL Listed transformer supplied with the kit. Plug the round end of the transformer provided into the round jack on the board inside the console. -
Page 8: Adjustment
Adjustment It is necessary to disassemble the console to adjust the gain controls. Disassembly of the console is done by turning the thumbscrew on the back of the console that secures the top to the bottom. Carefully open the console. For details on the location of the adjustments see Fig.1 on page 5. The incoming and outgoing gain controls should be adjusted clockwise, at the same rate, until feedback occurs, then counterclockwise until the feedback stops. -
Page 9: Diagram Fig.1
Console Audio Board POWER JACK INSIDE SPEAKER OUTSIDE MIC OUTSIDE SPEAKER INSIDE MIC CALL BUTTON I SPK O MIC O SPK I MIC BLACK WIRE TO PIN #4 WHITE/BLACK WIRE TO PIN #1 BUZZER INSIDE VOLUME CONTROL OUTSIDE VOLUME CONTROL FIG. -
Page 10: Troubleshooting
Troubleshooting Audio doesn't work Outlet on? Transformer plugged in? Check for 18vac at connector end. No 18vac? Replace transformer. Still doesn't work? Reseat handset in cradle (if present). No handset present? Replace console. No incoming (Assumes outgoing audio) Adjust gain. Check power to audio board. -
Page 11: Installation And Service Tool List
Installation and Service Tool List For Audio 1/8” And 3/8” Flathead Screwdrivers #0 And #2 Phillips Screwdrivers 1/16” And 3/32” Allen Wrenches 1/2" Open-End Wrench 1/4", 5/16”, 11/32”, 3/8”, and 1/2" Nut Drivers Wire Cutters Wire Strippers Wire Crimpers Volt Meter Electric Drill Drill Bits Level...