Table of Contents
Advertisement
4. Accessories & Replacement Parts:
ECCO PART NUMBER
ER1012
EZ1010
EZ1011
EZ1012
ECTC5-4
ECTC10-4
ECTC20-4
ER1013
5. Parts Identification:
Trigger input
Alarm output
Power supply (when
port A is not connected)
Connect to monitor
Notes:
1. Larger wires and tight connections will provide longer service life for components. For high current wires it is recommended that terminal blocks or
soldered connections be used with shrink tubing to protect the connections. Do not use insulation displacement connectors (e.g., 3M Scotchlock type
connectors).
2. Route wiring using grommets and sealant when passing through compartment walls. Minimize the number of splices to reduce voltage drop. High ambient
temperatures (e.g., under-hood) will signifcantly reduce the current carrying capacity of wires, fuses, and circuit breakers. All wiring should conform to the
minimum wire size and other recommendations of the manufacturer and be protected from moving parts and hot surfaces. Looms, grommets, cable ties,
and similar installation hardware should be used to anchor and protect all wiring.
3. Fuses or circuit breakers should be located as close to the power takeoff points as possible and properly sized to protect the wiring and devices.
4. Particular attention should be paid to the location and method of making electrical connections and splices to protect these points from corrosion and loss
of conductivity.
5. Ground termination should be only be made to substantial chassis components, preferably directly to the vehicle battery.
6. Circuit breakers are very sensitive to high temperatures and will "false trip" when mounted in hot environments or operated close to their capacity.
DESCRIPTION
3�/0.9m USB to UART Cable
Silicone Pad
Sensor Moun�ng Bracket, adjustable
horizontal addi�onal 15° & 30°
Universal Moun�ng Bracket, adjustable
horizontal and ver�cal addi�onal 5-30°
10�/3m Monitor Transmission Cable (4
pin avia�on interface, female to female)
33�/10m Sensor Transmission Extension
Cable
66�/20m Sensor Transmission Extension
Cable
10�/3m Sensor Transmission Cable (4
pin avia�on interface, female to male)
CONTROL BOX
Connect to sensor
Connect to buzzer &
configuration (B buzzer)
Sensor
Figure 1
Important!
Waterproof all connections whether inside or outside
the vehicle by using sealant and wrapping with
insulation tape. Wrap tape tightly,
overlapping by one-half widths so there are no gaps.
Connect to camera
Page 3 of 15
Advertisement
Table of Contents
