Table of Contents
Advertisement
If the cable is plugged into the PC while running the setup installation, unplug and re-plug the cable for the system to detect the device.
8.2.2 Configuration Tool Software Installation using ECCO Thumb Drive :
Run Radar Tool.exe from the thumb drive included with the radar kit to start configuration tool.
8.3 Using the Configuration Tool Software :
Connect the Control Box Port B to the PC with the USB serial port cable.
WARNING! Ensure that the Control Box is powered and there is NO VOLTAGE on the trigger input line before connection.
8.3.1 User Interface Overview :
The interface of the Configuration Tool is outlined below.
1. Click the "setup" button on the top bar to show settings interface. The bottom bar is a status bar, which is used to show the
connection state and application state.
Figure 16
Figure 17
Page 10 of 15
Advertisement
Table of Contents
