Related Manuals for BMB Technology Zada
Summary of Contents for BMB Technology Zada
- Page 1 BMB ULTRAFILTRATION SERIES INSTALLATION GUIDE Models: BMB ZADA ULTRAFILTRATION SYSTEM BMB ZADA PRO ULTRAFILTRATION SYSTEM BMB NANO ULTRAFILTRATION SYSTEM smart water technology...
-
Page 2: Table Of Contents
PREPARING THE FITTINGS REMOVING THE BLANK FITTINGS INSERTING THE ELBOW CONNECTORS FEED WATER CONNECTION TAP CONNECTION MOUNTING THE SYSTEM REPLACING THE FILTERS BMB ZADA / BMB ZADA PRO BMB NANO ULTRAFILTRATON SYSTEM IMPORTANT NOTE FOR NEW INSTALLATION AND REPLACEMENT FILTERS* NOTES... -
Page 3: Package Contents
PACKAGE CONTENTS Tubing Feed Water Valve Tubing Elbow Connections BMB Zada BMB Zada Pro BMB Nano UF System Overview Diagram with Tap... -
Page 4: Preparing The Fittings
PREPARING THE FITTINGS Both the Zada and Zada Pro have blank fittings (please skip this step with the BMB Nano UF) applied by default, this is to protect the inlet and outlet of the filtration systems during transport. First of all, let’s remove the blank fittings. -
Page 5: Feed Water Connection
FEED WATER CONNECTION The purpose of the feed water connection is to feed the system with water to be purified by tapping into the coldwater supply. Before you start, please ensure you have turned off the main water supply and always ensure there is a bucket or bowl and dry cloth for unforeseen circumstances. -
Page 6: Tap Connection
TAP CONNECTION First of all, a proper location to mount the tap needs to be selected, paying close attention to the placement of the tap stem under the counter. Ensure you use the correct type of drill bit for your counter type Hammer Drill Bit: Cement, Tile, Granite, Marble &... -
Page 7: Mounting The System
MOUNTING THE SYSTEM Mounting the BMB Zada, Zada Pro and Nano UF is really simple and all you need is 2 x wall plugs and 2 x screws (not supplied). Please ensure that there is at least 10cm empty below the bottom of the filter system to ensure you have enough space to pull the filter(s) down... -
Page 8: Replacing The Filters
filter. Have a towel handy for excess water dispensing as you’re removing the filters. BMB ZADA / ZADA PRO Replacing the filters have never been so simple. By default, the filters will be locked; simply unlock the filter then twist and pull it down to remove. Please follow guided diagrams below. -
Page 9: Important Note For New Installation And Replacement Filters
Important Note for New Installation and Replacement Filters You may get a metallic or an initial unpleasant taste / odour, this is due to the nano-particles within the filtration system. Simply flush the system by letting the water run for 15 minutes, then again after an hour or two later.
Need help?
Do you have a question about the Zada and is the answer not in the manual?
Questions and answers