Sanding Operation - Makita BO6030 Instruction Manual

► 1 . Notch 2. Guide
OPERATION

Sanding operation

CAUTION:
• Never switch on the tool when it is in contact
with the workpiece, it may cause an injury to
operator.
• Never run the tool without the abrasive disc. You
may seriously damage the pad.
• Never force the tool. Excessive pressure may
decrease the sanding efficiency, damage the
abrasive disc or shorten tool life.
Hold the tool firmly. Turn the tool on and wait until it
attains full speed. Then gently place the tool on the
2
1
workpiece surface. Keep the pad flush with the work-
piece and apply slight pressure on the tool.
Polishing operation
CAUTION:
• Use only a Makita genuine sponge pad, felt pad
or wool pad (optional accessories).
• Always operate the tool at low speed to prevent
work surfaces from damage/burning.
• Never force the tool. Excessive pressure may
decrease the polishing efficiency and cause
motor overload, resulting in tool malfunction.
1. Applying wax
1
► 1 . Sponge pad
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool at low
speed to smooth out wax.
NOTE:
• First, wax a non critical portion of the work sur-
face to make sure that the tool will not scratch
the surface or result in uneven waxing.
2. Removing wax
► 1 . Felt pad
Use an optional felt pad. Run the tool at low speed
to remove wax.
7 ENGLISH
1