Advertisement
Quick Links
Advertisement
Related Manuals for Ascent Communication Technology ACT AP300 XG-PON ONT
Summary of Contents for Ascent Communication Technology ACT AP300 XG-PON ONT
- Page 1 ACT AP300 XG-PON ONT Quick Reference Guide Revision A...
- Page 2 AP300 XG-PON ONT ACT AP300 XG-PON ONT Quick Reference Guide ACT Document Number: ACT AP300 XG-PON ONT QRG Quick Reference Guide Revision A Copyright © 2019 Ascent Communication Technology Limited. All rights reserved. Reproduction in any manner whatsoever without the express written permission of Ascent Communication Technology is strictly forbidden.
- Page 3 AP300 XG-PON ONT Table of Contents Safety Precautions........................4 1 Packing List ..........................5 2 Product Overview ........................5 3 Technical Specifications ......................5 4 Hardware Installation ......................6 5 Web configuration ........................8 5.1 Configure IP Address of Network Card ·········································································· 8 5.2 Log In ······························································································································...
-
Page 4: Safety Precautions
AP300 XG-PON ONT To use the device properly and safely, read the safety precautions carefully before using the device and strictly observe these precautions when using the device. Safety precautions: Do not look directly into the optical port without eye protection. ... - Page 5 AP300 XG-PON ONT Fireproof precautions: Keep the device away from large heat source equipment, bare flames, and high-power devices, such as electric heaters, candles, and blow drier, to eliminate safety risks. If there are aged cables or power socket facilities on the power supply line to or near the device, replace them in time to eliminate safety risks.
- Page 6 AP300 XG-PON ONT Step 1. Use an optical fiber to connect the optical port on the ONT. • The optical connector connected to the OPTICAL port is an SC/UPC connector. • To ensure normal use of fibers, make sure that the fiber bend radius is larger than 30 mm. Note Step 2.
- Page 7 AP300 XG-PON ONT S.N. Interface Instructions GPON The optical port is equipped with a rubber plug and isconnected to an optical fiber for transmission RJ-11 interface used to connect the voice equipment 3 to 6 LAN1 to 4 Rj-45 GE Ethernet interface used to connect the Ethernet interface of the computer.
- Page 8 AP300 XG-PON ONT Configure TCP/IP properties of your network card to Obtain an IP address automatically from ONU, or set the IP address of the computer with the same network mask of the ONU. PS:The default management IP address and subnet mask of the GPON terminal are as follows: ...
- Page 9 AP300 XG-PON ONT SSID: SSID indicates the name of a wireless network searched by the Wi-Fi terminal (see the device nameplate for the default SSID). Note Step 4. Choose Security, set authentication mode, and encryption mode. Click Apply/Save. Step 5. Choose Advanced, set other Wi-Fi parameters. Click Apply/Save. WPA PSK: WPA PreSharedKey indicates the authentication password for the Wi-Fi terminal to access a wireless network (see the device nameplate for the default WLAN Key).
- Page 10 Phone: +84 243 795 5917 WEB: www.ascentcomtec.com EMAIL: sales@ascentcomtec.com Specifications and product availability are subject to change without notice. Copyright © 2019 Ascent Communication Technology Limited. All rights reserved. Ver. ACT_AP300_XG-PON_ONT_QRG_V1a_Apr_2019 Solutions Provider for FTTx, RFoG, and HFC www.ascentcomtec.com Page 10 of 10...
Need help?
Do you have a question about the ACT AP300 XG-PON ONT and is the answer not in the manual?
Questions and answers