Advertisement
Installation Guide
Environmental Considerations
Ventilation: 10mm (0.4") of space is required between the device top/bottom edges
and the enclosure's walls.
Do not install in areas with: excessive or conductive dust, corrosive or flammable
gas, moisture or rain, excessive heat, regular impact shocks or excessive vibration,
in accordance with the standards and limitations given in the product's technical
specification sheet.
Do not place in water or let water leak onto the unit.
Do not allow debris to fall inside the unit during installation.
Install at maximum distance from high-voltage cables and power equipment.
Kit Contents
1 UAC-01EC2 module
Diagram
1
Snap-on clips
2
USB Host port
3
IO/COM Bus-Left
4
Bus Connector Lock
5
IO/COM Bus-Right
Bus Connector Cover
6
Functional Ground
Terminal
7
Ethernet port
8
EtherCAT LEDs
9
Status LED
Refer to the module's specification sheet for LED indications.
N
OTE
10
Module door
2
Physically hold the module in place.
Maintenance port: update module's firmware via USB flash
drive
Left-side Connector
Slide the Bus Connector Lock to the left, to electrically connect
the module to the CPU.
Right-Side Connector, shipped covered.
Leave covered when not in use.
Connect to the system earth
Supports EtherCAT fieldbus protocol
Green LEDs
Tricolor LED, Green/Red/Orange
Shipped covered with protective tape to prevent the door from
being scratched. Remove tape during installation.
Unitronics
Advertisement
