Enabling Devices Cheap Talk 6 User Manual page 2

Simple Communication! Simple Com
Simple Com Simple Com
Our new and unique Cheap Talk 6 for the visually impaired user is easy to
use. Each switch is outlined in black to make it easier to select your pre-
recorded message. It has a built in icon holder to hold your icons.
6 levels
•
225 total record time
•
6.25 seconds per message
•
Easy single message recording
•
Volume control
•
Excellent sound quality
•
Size: 20"L x 2½"H x 4¾"W. Requires Capability Switch and 4 AA Batteries.
Operation: Operation: Operation: Operation:
1. Carefully turn over unit to reveal battery compartment. Remove the
battery covers with a small Phillips Head screwdriver. Install four AA
size batteries into the holders observing polarity. Use alkaline
batteries only (e.g. Duracell or Energizer brand). Do not use
rechargeable batteries or any other type of batteries because they
supply lower voltage and the unit will not perform properly. Never mix
old and new batteries together or different brands or types together.
2. Turn the unit on by rotating the ON/Off/Volume knob clockwise and
adjust to an audible level. Next turn the L L L L EVEL SELECTOR
Level 1. To turn the unit off rotate the VOLUME CONTROL knob
counterclockwise until you hear an audible "click".
3. To record, depress and hold the red RECORD
back of the unit. While still holding the RECORD
of the six message switches on the front of the unit and speak into
the microphone located on the back of the unit.
4. Release both the message switch and the recording button when the
recording is finished. Play back your message by pressing and
releasing the same message switch used to record. Each of the
remaining switches can be recorded in the same manner.
5. The unit will retain recorded information indefinitely, even if the
batteries are removed. Previously stored information will only be
erased when a new recording is performed.
munication!
munication! munication!
EVEL SELECTOR knob to EVEL SELECTOR EVEL SELECTOR
RECORD button located on the RECORD RECORD
RECORD button, depress one RECORD RECORD
6. Move the LEVEL SELECTOR LEVEL SELECTOR knob to Level 2 and repeat Step 3.
LEVEL SELECTOR LEVEL SELECTOR
Continue programming additional levels in the same manor, if
needed.
7. It is recommended after use that the unit be turned off, to extend
overall battery life. This can be done by turning the VOLUME
CONTROL CONTROL CONTROL CONTROL knob counterclockwise, until you hear an audible "click".
8. Above the message switches there is an icon holding strip for placing
your icons, you can put individual icons or pictures or a strip
containing six icons or photos.
Troubleshooting: Troubleshooting:
Troubleshooting: Troubleshooting:
Problem: The unit fails to operate, or operates incorrectly. Problem: Problem: Problem:
Action #1: Action #1: Disconnect the power by turning OFF the unit for 20 seconds Action #1: Action #1:
to reset the unit. If the unit still does not work correctly after the power is
reconnected, check and replace the batteries observing proper polarity.
Action #2: If the unit still does not work, remove the colored flexible Action #2: Action #2: Action #2:
frames and make sure there is no dirt or obstacles between the black
rectangular plates and the housing of the unit.
Care of Unit: Care of Unit: Care of Unit: Care of Unit:
The Communicator for VI can be wiped clean with any household multi-
purpose cleaner and disinfectant. We recommend Simple Green, which is
a non toxic biodegradable all-purpose cleaner.
Do not submerge the unit, as it will damage the electrical components. Do not submerge
Do not submerge Do not submerge
Do not use abrasive cleaners, Do not use abrasive cleaners, as they will scratch the surface of the unit. Do not use abrasive cleaners, Do not use abrasive cleaners,
VOLUME VOLUME VOLUME
Rev 10/7 Rev 10/7/1 /17 7 7 7
Rev Rev 10/7 10/7 /1 /1