Advertisement
5. Now insert the aluminium rail at its original position.
Now insert the aluminium rail at its original position.
Take care that the PM5-SA4 plug-
exactly located in the corresponding slot of the
exactly located in the corresponding slot of the
aluminium rail as shown on the second photo below
own on the second photo below.
6.
Remount the lid of the connection terminal box and
Remount the lid of the connection terminal box and
close the controller casing.
7.
After completion and verification of the installation
After completion and verification of the installation
you can reconnect mains power supply to the
you can reconnect mains power supply to the
PoolManager
®
controller.
6
Technical data
Allowed ohmic resistance
of the connected current input
-in module is
Min.
Max.
0Ω
400Ω
PM5-SA4 Converter 4-20mA – User Manual
7
Menu Configuration
guration
The configuration menu for the PM5-SA4 plug-in module
The configuration menu for the
is called up as follows:
Menu Hotkey
Communication & Interfaces
Interfaces
Submenu Current outputs 4
7.1
Output of measured values
Output of measured values
Select the submenu for the current output of the desired
Select the submenu for the current output of the desired
measurement, e.g. Current output
Current output pH.
The following parameters can be set in this menu:
The following parameters can be set in this menu
Parameter
Possible
Possible
settings
settings
Current output
Current output
Current output
pH / Cl / Br / mV /
1.1 / 1.2 / 1.3 /
1.1 / 1.2 / 1.3 /
O2 / T1
1.4
(1)
Minimum value
Depends on measurement
Depends on measurement
(at 4 mA)
Maximum value
Depends on measurement
Depends on measurement
(at 20 mA)
(1)
Current output x.y means
means:
- x is the No. of the used plug
of the used plug-in connector
(usually this is plug-in connector
in connector 1)
- y is the No. of the current output
the No. of the current output
on the PM5-SA4 plug-in module
(2)
The default allocation is as follows:
The default allocation is as follows
- Current output 1.1: pH
pH
- Current output 1.2: Cl
Cl or Br
- Current output 1.3: mV
mV or O2
- Current output 1.4: Temperatur
Temperature T1
(3)
These Parameters can be used to adjust the desired
can be used to adjust the desired
measuring range which is output on the 4-20 mA
measuring range which is output on the 4
current output. The minimum
The minimum value always
corresponds with the minimum current signal of 4 mA;
corresponds with the minimum
the maximum value corresponds with
e corresponds with the maximum
current signal of 20mA.
The default settings are as follows:
The default settings are as follows:
Minimum. value
(at 4 mA)
mA)
pH
0,00 pH
0,00 pH
Cl or Br
0,00 mg/l
0,00 mg/l
mV
0 mV
0 mV
O2
0 l
T1
0°C
4-20mA:
Default setting
(default-set
Europe)
Depends on
measurement
(2)
(3)
(3)
in module
. value
Maximum value
(at 20 mA)
10,00 pH
10,00 mg/l
1000 mV
10 l
50 °C
4
Advertisement
