Troubleshooting Guide - XPower XD-85LH Owner's Manual

Troubleshooting Guide

PROBLEM
Dehumidifier
does not start
Dehumidifier
runs but humidity
level does not
decrease
Dehumidifier runs
but humidity level
does not decrease
POSSIBLE CAUSE
No electricity.
The power cord is not properly
plugged in.
The dehumidification system is
within startup process.
The humidity level setting is
too high.
The working area is not
enclosed.
There are other sources of
humidity in the room.
The humidity level has reached
the setting level.
The machine was tilted and
wasn't positioned upright for
enough time before use.
The air filter or air inlet/outlet is
blocked.
The environment temperature
is too low/high or the humidity
level is too low.
SOLUTION
Check for power supply.
Remove and reconnect the
power cord.
Wait for 3 minutes
(180 seconds) until the
dehumidification light stops
blinking.
Decrease the humidity level
setting.
Make sure the area is tightly
sealed.
Remove these sources or wait
until they completely volatilize.
Decrease the humidity level
setting, set to constant
dehumidification mode, wait
until the humidity level rises up
again.
Position the machine upright on
a level surface and wait for at
least 4 hours before next use.
Remove blockage.
The dehumidifier is designed
to work in an environment with
a temperature of 33 °F to 105
°F (0.6 °C to 40.6 °C) and
relative humidity level of 20%
and higher. Make sure the room
temperature/humidity does not
exceed this range.
English - 15