Table of Contents
Advertisement
Installation
Water inlet installation
Tap selection
The front end should be longer than 10mm. The tap exit end face
should be flat and smooth, if not file it to avoid leakage.
C
o
n
n
e
t c
h t
i e
1. Press down the slider and remove the inlet hose connector from the inlet hose ,
like below illustration 1.
2. Loosen the four bolts on the inlet hose connector till the tap can be accessed, then
set the inlet hose connector in the tap, see illustration 2.(if the tap caliber is too large and
could not set the inlet hose end, unscrew the four bolts and take out the bushing, tap exit
end must be flat, otherwise it will leak, see illustration 3)
Inlet hose
Illustration 1
3. Fasten the four bolts in the inlet hose connector evenly, see illustration 4.
4. Twist the fastening nut as the illustration ,see illustration 5.
Remark before twisting the nut, the threading is about 4mm above the upper surface of the nut, after twisting,
the threading is less than 2mm above the upper surface of the nut, see illustration 6.
Illustration 4
Suitable tap
l n
t e
h
o
s
e
c
o
n
n
Inlet hose connector
Slider
e
t c
r o
o t
h t
e
a t
p
Screwdriver
Illustration 2
Nut
Illustration 5
14
Not suitable tap
Bolt
Bushing
Illustration3
Before twisting,about 4mm
After twisting,less 2mm
Illustration 6
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
