Advertisement
Fig.4
Fig.6
3.2.
INSTALLING REPLACEMENT BUSH
3.2.1.
Place press clamp assembly (Fig.1.1) over the bush as in Fig.4. Place to one end of the bush rather than centrally.
3.2.2.
Using a 10mm spanner, tighten the screw to close the gap in the bush.
3.2.3.
Place the force screw (Fig.1.5) through the adaptor plate (Fig.1.3) and then place the adaptor plate on the adaptor sleeve.
3.2.4.
Place the adaptor sleeve against the suspension arm with the force screw going through the housing.
3.2.5.
Place the adaptor sleeve (Fig.1.4) against the outer face of the compressed bush and locate the bush against the other side of the
suspension arm. Put the adaptor cup plate (Fig.1.7) against the thrust washer and over the force screw. The arrangement is shown
in Fig.5
3.2.6.
Run the force screw nut up until finger tight. Using a spanner and socket as in 3.1.4. force the bush into the suspension arm housing
until the compressor is nearly touching the arm as in Fig.6.
3.2.7.
At this point, remove the socket from the force screw nut and release the tension on the press clamp assembly. Remove the press clamp
assembly over the adaptor cup plate.
3.2.8.
Replace the socket on the force screw nut and continue winding the bush into the housing until fully home as in Fig.7.
ALWAYS KEEP FORCE SCREW
WELL LUBRICATED.
Force screw maximum load 150Nm. Exceeding this load will shorten the life of the force screw. The force screw is considered to be a
To obtain a parts list and diagram please log on to www.sealey.co.uk, email sales@sealey.co.uk or telephone 01284 757500
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
consumable item and is NOT covered under warranty.
Parts support is available for this product.
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
DO NOT USE AIR TOOLS.
01284 757500
Web
01284 703534
email
Fig.5
Fig.7
www.sealey.co.uk
sales@sealey.co.uk
VSE5586
Issue:1 - 11/10/13
Advertisement
