Whirlpool AGB 776/WP General Instructions Manual page 10

Most of the functioning inconveniences are generally due to mere reasons or to defective electrical connections. These can be easily be solved:
The unit does not start:
Check if there is power at the wall socket;
•
Check that the unit is properly plugged.
•
The internal temperature is not cold enough
Check if the door is well closed or if there is something that doesn't allow the door cabinet to close perfectly:
•
Check that the cabinet is not placed too close to any heating source;
•
Check that the cabinet leans against the wall and that the front grill is free from any obstructions;
•
Check the thermostat position;
•
Check that the condenser is not blocked by dirt; to clean it use a brush or a vacum- cleaner.
•
The unit is noisy
Check that all bolts and nuts are properly fasten
•
Check if any pipe or blade touches any other parts of the cabinet
•
Check that the cabinet is placed on a plane surface
•
If there is moisture inside the cabinet:
It is normal in those periods with high humidity
•
Part of this humidity must be considered normal were the products are not wrapped or if they are inside containers without lid;
•
It can be cause by frequent opening or long opening of the door. Check if the door close properly.
•
IF THE INCONVENIENCES WILL NOT STOP PLEASE CONTACT THE NEAREST ASSISTANCE-SERVICE CENTRE
ATTENTION THIS OPERATION MUST BE DONE ONLY BY AUTHORISED TECHNICAL SERVICE OR QUALIFIED
A)
INSIDE LAMP
1. Remove the plug from the socket;
2. Take off the lamp-lock from its seat with a screwdriver;
3. Take off the light screen making it move on the right and then gently press it downward;
4. Replace the light
5. Invert the operation order to place the light
B) CANOPY LAMP
Remove the plug from the socket;
•
Unscrew the fastening screws to take off the canopy
•
Replace the light
•
Invert the operation order to place the light
•
6 INCONVENIENCES AND REMEDIES
HOW TO REPLACE THE LIGHTS
PERSONNEL